DSM
|
EVO
|
OEM
|
EVO X
|
3000GT
|
SUBARU
|
EVO VIII-IX FUEL SYSTEM AND COMPONENTS
Our On-Line Catalog and inventory is constantly growing. If you don't see what you need, give us a call. For questions and ordering call (585) 730-4314.
|
|
 |
|
|
STM FUEL RAIL VIII-IX
The STM fuel rail is made of polished aluminum, then anodized black and purple for a brilliant finish. The rail will accept -6AN and -8AN fittings (included in the price and come anodized black) and includes mounting hardware. USA Made!
|
|
|
|
STM EVO VIII-IX FUEL KIT
Now made exclusively with Russell ProClassic nylon hose. It's MUCH easier to work with, extremely lightweight and it will not scratch paint. Choose from the standard -10/-6 Fuelab Regulator or the new Mini -6/-6. Includes all fittings to make this kit safe for E85, race gas and methanol.
|
|
|
|
|
STM FUEL PUMP RE-WIRE KIT
The STM kit comes with everything shown to safely and reliably get your fuel pump the power it needs! Includes: relay, relay pigtail, 16' power cable, 3' ground cable, 2 10 gauge ring terminals, in-line fuse holder, 30 amp fuse, 5 cable ties, black wire loom and step by step instructions.
Price: $30.00
|
|
|
|
|
-6AN STM FUEL RAIL FITTINGS
-6AN fuel rail fittings available in aluminum or anodized finish safe for E-85 and race fuels. Machined and anodized in Rochester, NY. Fittings fit both Inlet & Outlet Evo VIII-IX.
|
|
|
|
|
INJECTOR DYNAMICS 2200cc (Set of 4)
The new Injector Dynamics ID2000 flows 2200cc/min at 3 bar (43.5psi) and is high impedance. That means no injector resistor or injector driver is needed. With the capability of running up to 130psi and flowing 3700cc/min, the needs for running multiple injectors per cylinder are gone on all but the most demanding methanol applications.
Price: $1000.00
|
|
|
|
|
INJECTOR DYNAMICS 1000cc (Set of 4)
Bosch's newest generation injectors are now available in a 1000cc high impedance injector!!These are a 48mm long body, shorter than normal injectors. The adaptor tops make them "normal" 60mm length. These have a droplet size comparable to a 600cc Siemens injector and way better spray pattern and atomization than any other 1000cc injector on the market.
|
|
|
|
|
INJECTOR DYNAMICS 725cc (Set of 4)
Injector Dynamics has done it again, now in a 725cc version! These are a 48mm long body, shorter than normal injectors. The adaptor tops make them "normal" 60mm length. The proper battery comp values are also provided with each set so you can set it up in your computer and have consistent a/f ratios as battery voltage fluctuates. Most other injectors don't offer that information at anything other than 1 voltage level.
Price: $500.00
|
|
|
|
|
FIC BLUEMAX 2150CC (Set of 4)
2150cc Saturated / High Impedance Ball & Seat Injectors fit 90-99 DSM & Evo VIII-IX. These are the largest high impedance injector ever! Great linearity and idle will work at elevated fuel pressure. Best injector for E85 applications! Set of 4 injectors includes pigtails. DO NOT USE WITH "Q16" or OTHER OXYGENATED FUELS!
Price: $780.00
|
|
|
|
|
FIC BLUE MAX INJECTORS (EVO VIII-IX)
FIC's brand new BlueMAX Injector Series for the Evo VIII-IX offer 100cc increments from 1250 up to 1850cc injectors!
Peak & Hold, Low Impedance Ball & Seat Injectors. Sold as a set of 4.
|
|
|
|
|
FUEL INJECTOR CLINIC (EVO VIII, IX & X)
Mitsubishi Evo VIII, IX & X Injector Sets. Sold as a set of 4.
Evo VIII-IX, Peak & Hold, Low Impedance Injectors are available from 650-1150cc.
Evo X Saturated, High Inpedance, Ball & Seat Injectors are available in 525, 625, 725, 800 and 900cc.
Click image for all applications.
|
|
|
|
|
FUEL INJECTOR SEAL KIT
This set comes with VITON custom lower seals for Fuel Injector Clinic injectors which can handle more heat and boost.
Price: $25.00
|
|
|
|
|
DEATSCHWERKS 800cc INJECTORS (EVO X)
This set of 4 800cc Deatschwerks Evo X injectors are flow balanced in-house by Deatschwerks within 1-2%. These are 100% new Denzo manufactured injectors with a drop-in fitment. Click for more info.
Price: $399.00
|
|
|
|
|
FUELAB | PRODIGY IN-LINE FUEL PUMPS
Prodigy Fuel Pumps are the auto aftermarket's first and only speed controllable DC brushless driven fuel pump. With digital fuel delivery you get unheard of electro-mechanical efficiencies in a package half the size of competing pumps (3lb, 6.9 x 2.63") with 6 colors and 4 models to choose from rating up to 1800 HP! If you plan on making serious power, these are the pumps you should be looking at. Click for all applications.
Price: $408.00 - $650
|
|
|
|
|
FUELAB | FUEL PRESSURE REGULATORS
FUELAB 515 Series Fuel Pressure Regulators are designed with performance and flexibility in mind. They accept port style and non-port style union fittings without interference. Available in 6 colors with -10AN or -6AN inlets, supporting fuel injected applications up to 90 PSI. Both the 515 Series Fuel Pressure Regulator have a -6AN return port located on the bottom. Click for all applications.
Price: $140.00
|
|
|
|
|
FUELAB 818 SHORT FUEL FILTERS
FUELAB In-Line Fuel Filters keep your engine running clean featuring male AN / 37° flared fitting end caps, so you can attach them directly to other fuel system components. All six colors are available in -6, -8 and -10AN with 10 micron paper filter elements. Excllent filtration and easy to install compact design. Click for all applications.
Price: $82.00
|
|
|
|
|
FUELAB 828 LONG FUEL FILTERS
FUELAB In-Line Fuel Filters keep your engine running clean featuring male AN / 37° flared fitting end caps, so you can attach them directly to other fuel system components. All six colors are available in -6, -8 and -10AN with 10 micron paper filter elements. These long filters offer more filtration and longevity. Click for all applications.
Price: $99.00
|
|
|
|
|
FUELAB | REPLACEMENT FILTER ELEMENTS
All racers demand top engine performance, but what ensures that? Clean fuel! The celluose (paper) element is for gas and diesel only where you may use the stainless filters with E85. Available for the 5" and 3" filters. The finer the micron, the better the filtration. Click for all applications.
Price: $11.00 - $45
|
|
|
|
|
AMS FUEL SURGE TANK SYSTEM WITH PUMP
The AMS Evo VII-IX Surge Tank Kit prevents fuel starvation caused by hard cornering, braking, and acceleration. Because of the EVO's two sided tank design it is common for one side of the tank to starve when running less than a 1/4 tank of fuel. This kit uses your existing in-tank pump to feed a small aluminum reservoir that stores fuel. The fuel is then fed to the engine using an in-line Walbro 255 lph pump. Click for more info.
Price: $720.00
|
|
|
|
|
AMS EVO IV-IX REPLACEMENT FUEL RAIL LINE
The AMS EVO IV-IX Replacement Fuel Rail Line increases fuel flow and makes your Evo safer by eliminating the factory hard line. In an effort to help improve the reliability and safety of AMS's record setting Time Attack car, they needed to replace the stock fuel line hard section at the rail. This hard line right off the rail has been known to fail or crack spraying fuel all over the engine bay. Click for more Info.
Price: $79.00
|
|
|
|
|
AMS FUEL RAILS (EVO VIII-IX)
Choose from AMS's Race Fuel Rail or the High Flow Rail both providing increased fuel flow which is necessary at higher boost levels. These are precision CNC machined 6061 billet aluminum with thick flanges for durability. Click for more info on these items.
Price: $179.00
|
|
|
|
|
AMS FUEL RAIL (EVO X)
The AMS X Fuel Rail is CNC aluminum and comes anodized in Red or Black with the signature AMS logo. With a -6AN (7.5 mm) diameter inlet and outlet it dwarfs the stock rail by over 25% in flow area. This is true bolt on part that will install with your factory fuel lines, fuel pressure regulator and will work with all factory style fuel injectors. Click for more info.
Price: $239.00
|
|
|
|
|
FULL BLOWN DUAL PUMP HANGER (EVO VIII-IX)
Full Blown's dual pump hanger for the Mitsubishi Evolution VIII-IX allows you to drop two Walbro fuel pumps into the stock gas tank. The days of drilling the stock gas tank and running loud external pumps are over!
This is a must-have for those who are looking to make 500-1000hp. This kit comes complete with everything that you need to run a dual pump setup (minus the lines and hose ends, but we have all you'll need in our DIY section).
|
|
|
|
|
BUSCHUR DOUBLE PUMP FUEL SYSTEM
This is a TRUE drop in setup for your Evo VIII-IX and it is all done while retaining the stock fuel lines and sending unit. No modification is needed to run this and comes with everything needed for install. Click for more info as there may be a core charge.
|
|
|
|
|
HKS FUEL RAIL (EVO VIII-IX)
This is a direct bolt-on replacement of your factory fuel rail, and allows for larger injectors to be added. HKS Fuel Rails are machined out of aluminum and anodized HKS signature purple for durability and visual appeal.
Price: $425.00
|
|
|
|
|
FIC FUEL RAIL (EVO VIII-IX)
FIC'S Evo Fuel Rail is custom machined and re-anodized (E85 compatible) AN fittings increase the flow to the first injector. Fuel rail ID is 11/16" (larger than -10)! Kit includes 2 mounting spacers and bolts and comes with your choice of inlet and outlet -AN fittings from -6 to -10AN. Available in red, silver or black.
|
|
|
|
|
AEROMOTIVE FUEL RAIL (EVO VIII-IX)
This high flow, billet fuel rail is a direct replacement for the factory EVO VII / IX fuel rail. Uses the factory feed line, regulator and return line. Features custom, removable, Aeromotive -8 AN ORB (O-ring Boss) to OEM adapters.
Price: $165.00
|
|
|
|
|
AEROMOTIVE FUEL PRESSURE REGULATORS
1:1 Fuel Pressure Regulator with two -6AN inlet ports, one -6 return port and 1/8" NPT gauge port.
Price: $150.00
|
|
|
|
|
BOSCH 044 IN-LINE FUEL PUMP
Designed to be mounted outside of your gas tank, providing 300LPH of flow and can be used in sequence with an in-tank Walbro fuel pump. Click for more info.
Price: $220.00
|
|
|
|
|
WALBRO 255 IN-LINE FUEL PUMP
Walbro's in-line 255 fuel pump. Mounts outside the tank and can be coupled with another pump for extra fuel. Sold as pump only or include the install kit.
Install Kit includes: (2) 9mm barb fittings and mounting adapter.
|
|
|
|
|
WALBRO FUEL PUMPS
Fuel pump only- no install kit required. Walbro 255-HP and 190-LPH available.
|
|
|
|
|
0-100 PSI FUEL PSI GAUGE
1.5" diameter liquid-filled gauges have a black face with white pointer and numbers. Liquid-filled for accurate, steady readings. Gauges have a 1/8" NPT center back male fitting.
Price: $19.00
|
|
|
|
|
OEM INJECTOR O-RING
How many of these have you ripped? OEM O-rings and they fit most other injectors as well.
Price: $4.00 each
|
|
|
|
|
OEM LOWER INJECTOR INSULATOR/ O-RING
Located in the head, these rings can dry rot, crack and cause boost leaks.
Price: $2.50 each
|
|
|
|
|
OEM FUEL RAIL SPACERS
These don't break, won't wear out and will last forever... until you lose one.
Price: $4.00 each
|
|
|
|
|
DO-IT-YOURSELF PARTS
We've got a whole section of DIY parts, fittings, stainless line and pushlock hose. Alot of you have some seriously custom set-up's out there so we've got the stuff you need!
|
|
|
More Parts Coming Soon
Please bear with us as we prepare and update the inventory for our new website. If you don't see what you're looking for, give us a call or email and we can get it for you at a great price!
|
|
|
|
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |